Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

commands change after reboot

hi

i have this scenario: ccm 6.1, e1 configured as mgcp gateway on 2821

i have a problem that is everytime when the router reboots this command:

mgcp call-agent 192.168.1.10 2427 service-type mgcp version 1

changes to

mgcp call-agent my-router 2427 service-type mgcp version 1

i mean after reboot the ip address in the above command changes to gateway name

so i have to change the name to ip address manually again so that the gateway is going to register with ccm

another same issue, e1 is configured with framing no-crc4, also after reboot this framing type is removed and i have to configure it manually again so that isdn layers will come up and work fine...

did anyone face like this before

plz help

1 REPLY
Silver

Re: commands change after reboot

Maybe: I can't remmeber exactly.

no ip domain name

no ip name-server

or if you can't beat 'em, join 'em. Just config a static host

ip host my-router 192.168.1.10

As far as the framing, set it in CallManager. Sounds like you have "ccm-manager config" turned on. When you reboot the router, it is downloading the config from CallManager which is "wrong"

169
Views
5
Helpful
1
Replies
CreatePlease to create content