Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Commands to Verify Transcoder config and sessions.

I have configured numerous 28XX for transcoding resource on various versions of callmanger and they work fine. However I have never been able to view the live transcoding rtp sessions as they occur on the router (28XX). I know that the transcoder is doing its job - as i can browse to the IP address of the Cisco phone and see that it rtp stream terminates on the transcoding router (28XX). I would however love to know the command to view the transcding sessions that are currently being used on the router (28XX). I have tried many show commands that i can see on the router without success, Can any one help??

Over the years I have used various levels of IOS - so I am sure its not a buggy IOS.

Thanks In advance Mark

4 REPLIES
Hall of Fame Super Red

Re: Commands to Verify Transcoder config and sessions.

Hi Mark,

Have you tried;

show voice dsp group all

show voice dsp detailed

show dspfarm dsp active

Hope this helps!

Rob

New Member

Re: Commands to Verify Transcoder config and sessions.

Hi - I will try and update all.

Many Thanks Mark

Cisco Employee

Re: Commands to Verify Transcoder config and sessions.

I prefer 'sh sccp conn' for this.

Re: Commands to Verify Transcoder config and sessions.

Mark,

Wouldn't "show sccp connections" give you the data you are looking for? Or

is there something missing? I know I have used it for TRP/MTP and CFB

recently. Can't recall the last time I looked at a hardware transcoded

session.

HTH.

Regards,

Bill

On 9/9/10 12:53 PM, "wrightmp"

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

389
Views
0
Helpful
4
Replies