Communications Manager 6.1.2 Calls failing from corporate directory
We currently have Callmanager 6.1.2 configured to synch users from AD - LDAP. When users go into the Corporate Directory on their phones to do a search the number returned is the 10 digit number that is set in AD. I have a translation to strip the first 6 digits off. The issue is that the number is returned from the search with the " - " character in between the area code and prefix. Example - the number returned from the search would look like 801-555-1234 when I press dial the call fails with an error " your call cannot be completed as dialed..." If I press 'editDial' and remove only the dash - from the number then it works fine. The only model of phone that seems to not choke on the dash - character is the 7921 wireless phones. I can have them go into AD and modify the number from 801-555-1234 to 8015551234 but wanted to see if anyone had run into this issue???
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...