Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Conf Bridge CM 6.1

Trying to register a new Conf bridge with CM 6.1 and it shows Registration "Rejected". Here is the GW config. Ideas?

sccp local Loopback0

sccp ccm 10.224.13.12 identifier 2

sccp ccm 10.224.13.11 identifier 1

sccp

!

sccp ccm group 1

bind interface Loopback0

associate ccm 2 priority 1

associate ccm 1 priority 2

associate profile 10 register SIN-CONF

!

dspfarm profile 10 conference

codec g711ulaw

codec g711alaw

codec g729ar8

codec g729abr8

codec g729r8

codec g729br8

maximum sessions 2

associate application SCCP

2 REPLIES

Re: Conf Bridge CM 6.1

I'm not sure about "SIN-CONF". You might try removing the "-". Also, make sure the bridge name in CUCM matches this exactly.

Hope this helps.

Brandon

Re: Conf Bridge CM 6.1

I experienced the same issue. Did you configure it as IOS enhanced conference bridge or just IOS conference bridge, which does matter.

also perform a shut/no shut on your profile 10

Please remember to rate useful posts, by clicking on the stars below.

306
Views
0
Helpful
2
Replies
CreatePlease to create content