Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Conference between CUCM 8 and CME

Hi voice team!

I have a CUCM (site A) with conference bridge working properly to internal calls and with another site C using CME.

But, the conference between CUCM (site A) and CME (site B) is not working...

The Site B configuration is bellow:

 

voice-card 0

dsp services dspfarm

interface Vlan1

description VLAN-IT7

ip address 172.22.0.1 255.255.255.0

ip flow ingress

ip nat inside

ip virtual-reassembly in

ip tcp adjust-mss 1452

h323-gateway voip interface

h323-gateway voip bind srcaddr 172.22.0.1

sccp local Vlan1

sccp ccm 172.22.0.1 identifier 10 version 7.0

sccp

!

sccp ccm group 1

associate ccm 10 priority 1

associate profile 1 register confe1

!

dspfarm profile 1 conference

codec g729br8

codec g729abr8

codec g729ar8

codec g729r8

codec g711alaw

codec g711ulaw

maximum sessions 2

associate application SCCP

telephony-service

sdspfarm units 10

sdspfarm tag 1 confe1

conference hardware

max-conferences 4 gain -6

thanks.

4 REPLIES
Cisco Employee

Conference between CUCM 8 and CME

who is initiating the conference?

cme phone or cucm phone??

thanks,

Vipul JIndal

Community Member

Conference between CUCM 8 and CME

Hi Vipul,

CUCM phone is initiating the conference.

thanks.

Hall of Fame Super Silver

Conference between CUCM 8 and CME

Then the CME configuration is irrelevant here as the issue is on CUCM side, are you using hardware or software bridge?

If software then what is the region between the CME trunk and the phone (what codec is defined) as you may need transcoders if G729 is defined due to the fact that software conference bridge only supports G711.

Chris

Community Member

Conference between CUCM 8 and CME

Ah ok. I need to chenge the WAN codec for g711. I ´m going to test this..

thanks

427
Views
0
Helpful
4
Replies
CreatePlease to create content