Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Conference call failure

Hi

We have CUCM 8.0.3 on production.

Some reason 3 party conference is not working. The moment we add 3rd call to conference, call get drops.

We have observed, there is no problem with codec mismatch. Calls are using g711.

Conference fails for all internal calls as well as all PSTN calls via gateway also mix of internal and PSTN calls.

I have attached the RTMT log files from CUCM.

Extension from Conference initiated is 3443.

Other two extensions used for conference call is 3883 and 3442. PSTN line used for conference is 2252586

Pls suggest

Everyone's tags (1)
7 REPLIES
Hall of Fame Super Silver

Conference call failure

What conferencing resources are you using hardware/software?

Does the initiating party have MRGL/MRG with Conference bridge defined in it?

Chris

New Member

Conference call failure

Dear Chris

Configured CUCM software based resourses.

Conference Bridge, MTP, MRG and MRGL are defined and applied.

Conference was working and may be since few days it is stopped working.

I have attached log files previously, any hint from these files?

Rgds

Rajesh

Green

Conference call failure

Hi,

Check that the streaming service is running on

your CUCM servers

Regards

Alex

Regards, Alex. Please rate useful posts.
New Member

Conference call failure

Yes, Steaming service is running.

All Pub and SUB, MTP, CFB are registered.

Any other hint?

Rgds

Rajesh

Hall of Fame Super Silver

Conference call failure

Have you tried resetting the streaming service in CUCM?

Has any configuration changed, i.e. regions/MRGLs, etc?

Chris

New Member

Conference call failure

Dear Chris

I have restarted steaming service, but still same problem.

I have created separate MRG and MRGL and Device Pool. Also all call codecs are g711.

Still conf call cant establish.

Any clues from the logs I attached?

Rgds

Rajesh

New Member

Conference call failure

Hi all

I am facing similar issue with our CUCM 8.6 which is also in production. Have just switched our office system from CME to CUCM 8.6 last month. But ever since, 3-party conference and MOH doesn't seem to be working. I've configured MGRL and conference bridge. Let me add here that 3-party conference is working with internal extensions only. If PSTN parties are invloved, the call drops on pressing the Confrence button. Any advice is appreciated.

Cheers

Binu

1228
Views
0
Helpful
7
Replies