I am configuring the CME to enable conferencing. I get <0-0> when I try to configure max sessions, which means I can't have conferencing. I have enough DSPs. Please see the below (truncated) config.
dsp services dspfarm
sccp local FastEthernet0/0.2
sccp ccm 10.4.3.1 identifier 1 version 4.1
sccp ccm group 1
associate ccm 1 priority 1
associate profile 2 register transcode
associate profile 1 register mtp001d70103e30
keepalive retries 5
dspfarm profile 2 transcode
maximum sessions 2
associate application SCCP
dspfarm profile 1 conference
sdspfarm units 1
Appreciate if someone could help me out.
Go to Solution.
I would tend to say you do not have enough DSP's. What DSP modules are in the router and what cards are in the router. sh tech please.
i have to agree with Chad most probably not enough DSPs, if possible also post the sh run.
rememember, conferencing takes a WHOLE dsp
ie: if you have 15 channels to spare... that won't do since you need the whole 16 channels
issue a sh voice dsp to see how many channels are already allocated
if this helps, please rate