Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Conferencing resource on 2811

Ok need to verify this one thanks..

Setup - CUCM 6.1 at Main Site. 2811 gateway (1 x 30 channel pri) at remote site. Link between both is small mpls pipe.

Remote site want to do conferencing but not use bandwidth across the Wan.

Can i setup the 2811 as a hardware resource for the remote site so that the 2811 gateway uses its dsp resources to handle the conf call.

If so how many conf calls can i do maxmum. I read that i can do 6 per bridge. So is that 6 max per conf call?

Anything else i need to be aware of for this?

Thanks,

Taff

2 REPLIES
Cisco Employee

Re: Conferencing resource on 2811

The best practice is exactly that, resources as close as possible to the ones who will use them.

Just configure the MRGLs properly and they will use their resources when pressing conference or doing meet-me

I already covered all the "how many and how much" last week on this post

https://supportforums.cisco.com/message/3022308#3022308

It's exactly the same info you can use.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: Conferencing resource on 2811

Fantastic! Thanks..

155
Views
0
Helpful
2
Replies
CreatePlease login to create content