Conferencing resource on 2811

clougher01 · ‎02-24-2010

Ok need to verify this one thanks..

Setup - CUCM 6.1 at Main Site. 2811 gateway (1 x 30 channel pri) at remote site. Link between both is small mpls pipe.

Remote site want to do conferencing but not use bandwidth across the Wan.

Can i setup the 2811 as a hardware resource for the remote site so that the 2811 gateway uses its dsp resources to handle the conf call.

If so how many conf calls can i do maxmum. I read that i can do 6 per bridge. So is that 6 max per conf call?

Anything else i need to be aware of for this?

Thanks,

Taff

Jaime Valencia · ‎02-24-2010

The best practice is exactly that, resources as close as possible to the ones who will use them.

Just configure the MRGLs properly and they will use their resources when pressing conference or doing meet-me

I already covered all the "how many and how much" last week on this post

It's exactly the same info you can use.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

clougher01 · ‎02-24-2010

Fantastic! Thanks..