Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Config different e&m signalling on the same E1 circuit

Hi,

Is it possible to config different e&m signalling (as below) from the same E1 controller?

controller E1 0/1/0
framing NO-CRC4
clock source internal
ds0-group 0 timeslots 1 type e&m-melcas-immed
ds0-group 1 timeslots 2 type e&m-immediate-start

Thanks

Tom

2 REPLIES
Cisco Employee

Re: Config different e&m signalling on the same E1 circuit

Hi Tom,

Though its not common as most of the time I have seen same signaling

for all the channels/DS0s on the T1 or E1 span, it is very much possible

to do what u mentioned. Just make sure to match it up on the other side

for each DS0.

For each ds0-group that is created (for one or more timeslots/DS0) you would

see a different voice-port so you'd need to be careful in planning/configuring

your inbound and outbound dialpeers for call routing in/out the E1 circuit.

HTH,

DK

New Member

Re: Config different e&m signalling on the same E1 circuit

Thanks. It's helpful.

186
Views
0
Helpful
2
Replies
CreatePlease login to create content