Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuration E1 R2 Trunks

Guys,

need help to configure our gateway 2811. I have two (2) E1 ports.

Port: 0/0/0 - to be used for DID

Port: 0/0/1 - to be used for DOD

Can you guide me to configure first my controller then a sample dial-peer I will use to use for incoming and outgoing.

I want to use port: 0/0/0 for DID and port: 0/0/1 for outgoing.

I need your advice and quick action to this issue.

regards.

1 REPLY
New Member

Re: Configuration E1 R2 Trunks

hi, please find below configure is workable in our Manila Branch. I hope this can help you.

!

voice service voip

allow-connections h323 to sip

allow-connections sip to h323

h323

sip

!

!

voice class codec 99

codec preference 1 g711ulaw

codec preference 2 g729br8

!

!

voice translation-rule 1

rule 1 // /5/

!

!voice translation-profile inbound

translate called 1

!

!

controller E1 0/0/0

framing NO-CRC4

ds0-group 0 timeslots 1-15 type r2-digital r2-compelled ani

cas-custom 0

country philippines

dnis-digits min 1 max 3

description TYPE=PRI DEST=xxx BW=2M!

!

voice-port 0/0/0:0

translation-profile incoming inbound

!

!

dial-peer voice 402 voip

description xxx

preference 1

destination-pattern 5...

voice-class codec 99

voice-class h323 1

session target ipv4:

dtmf-relay h245-alphanumeric

ip qos dscp cs5 media

no vad

!

139
Views
0
Helpful
1
Replies