Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configure 2 mc3810's to double the available analog ports.

I presently have an mc3810 with 6 e&m ports connected via t1 voatm over a microwave link to a distant mc3810 with 6 e&m ports. Is it possible to add a mc3810 at each end connected by their ethernet ports with a x-over cable to double the number of e&m ports available without using another t1? Thanks

1 REPLY
Cisco Employee

Re: Configure 2 mc3810's to double the available analog ports.

This will work as long as its an MC3810 "V3" the "V3" unit supported H.323 dial-peers, which you will use to route calls on the second 3810, you add, to the 3810 with the t1 voatm connection. Basically voip between the two units with a cross over cable.

104
Views
0
Helpful
1
Replies