Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Configure 28xx to emulate PRI

We have CUCM 8.5 but one of our locations has a Shoretel.  We tried a SIP trunk between the 2 and most things work but some do not and the Shoretel guys blame SIP.  We are looking to put in a  VWIC2-2MFT-T1 in a 2821 to emulate a PRI to the Shoretel.  I am going to continue to take calls on the CUCM and send 4 digits to the Shoretel.  In addition the Shoretel will send calls directly to my CUBE.  What would my dial-peer configuration look like?  I'm sure getting dial-peers down is easier than I make it out to be but for some reason it doesn't click with me. So far this is what I have come up with.

dial-peer voice 50 voip

description Outbound

destination-pattern [2-9].........$

incoming called-number [1-7]...$

direct-inward-dial

session protocol sipv2

session target ipv4:CUBE-IP

forward-digits 10

!        

dial-peer voice 51 voip

description Outbound

destination-pattern [2-9].........$

incoming called-number [1-7]...$

direct-inward-dial

session protocol sipv2

session target ipv4:CUBE-IP

forward-digits 10

!        

dial-peer voice 52 voip

description Outbound

destination-pattern [2-9]......T

incoming called-number [1-7]...$

direct-inward-dial

session protocol sipv2

session target ipv4:CUBE-IP

forward-digits 7

!

dial-peer voice 100 pots

description Inbound Dialin

translation-profile incoming Outbound

destination-pattern [1-7]...

incoming called-number .

no digit-strip

direct-inward-dial

port <0/1/0:23>

Thanks in advance.

Everyone's tags (3)
245
Views
0
Helpful
0
Replies
CreatePlease to create content