Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configure CDR

Dears,

I have billing software (installed in PC) that will gather 2 CDR file from AVAYA call manaher and Cisco getway, I was able to send CDR from Avaya( easily send the file by specify PC's IP  that billing software is installed on it )    but I can't configure Cisco to be able to send CDR file to the billing software 

So could anyone help me on that

---

------------------ show version ------------------

Cisco IOS Software, 2800 Software (C2800NM-IPVOICE_IVS-M), Version 12.4(24)T6, RELEASE SOFTWARE (fc2)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2011 by Cisco Systems, Inc.

Compiled Tue 23-Aug-11 01:31 by prod_rel_team

ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)

VGW1 uptime is 3 weeks, 1 day, 1 hour, 25 minutes

System returned to ROM by reload at 11:35:13 UCT Sat Jun 1 2013

System image file is "flash:c2800nm-ipvoice_ivs-mz.124-24.T6.bin"

Cisco 2851 (revision 53.50) with 249856K/12288K bytes of memory.

Processor board ID FTX1144A29J

2 Gigabit Ethernet interfaces

1 Serial(sync/async) interface

12 Voice FXO interfaces

DRAM configuration is 64 bits wide with parity enabled.

239K bytes of non-volatile configuration memory.

62720K bytes of ATA CompactFlash (Read/Write)

Configuration register is 0x2102

------------------ show running-config ------------------

Everyone's tags (1)
1 REPLY
Hall of Fame Super Gold

Configure CDR

Wrong forum, post in "IP telephony". You can move your post using the actions panel on the right.

320
Views
0
Helpful
1
Replies
CreatePlease login to create content