Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configure CME to route mobile calls through a BRI card

Hi,

Can anybody assist with the above? I also need to put a basic config on the BRI card. I think I have it right but not sure.

interface BRI0/3/0
no ip address
isdn switch-type basic-net3
isdn protocol-emulate network
isdn incoming-voice voice
isdn skipsend-idverify
!

Best Regards,

Paul.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Configure CME to route mobile calls through a BRI card

It is the very exact same thing, anyway understanding of DPs logic, is key to success.

Please remember to rate useful posts clicking on the stars below.

5 REPLIES
Hall of Fame Super Gold

Re: Configure CME to route mobile calls through a BRI card

Check your GSM box if it requres PBX to be network-side. It is not said that is the case, or it can have dual interface.

New Member

Re: Configure CME to route mobile calls through a BRI card

Hi,

Thanks for the quick response. It does not require network side. When i issue a sh voice call summary I see sub interfaces for each of the isdn ports on the card. Is there a config required for each of these interfaces to router the mobile traffic?

A sh isdn status shows the port I have configured as active.

Thanks,

Paul

Sent from my iPhone

Hall of Fame Super Gold

Re: Configure CME to route mobile calls through a BRI card

Then you do not neet to confgiure network side under BRI.

Subinterface on the BRI are never ever configured. Just handle it like any other ISDN interface.

Check however if the GSM box want static TEI in which case configure it.

New Member

Re: Configure CME to route mobile calls through a BRI card

Thanks,

I think where it gets confusing for me is configuring a Dial-peer group for the ports and mobile networks as it seems to be different than creating groups for POTS lines.

Paul.

Hall of Fame Super Gold

Re: Configure CME to route mobile calls through a BRI card

It is the very exact same thing, anyway understanding of DPs logic, is key to success.

Please remember to rate useful posts clicking on the stars below.

268
Views
0
Helpful
5
Replies
CreatePlease to create content