05-13-2010 01:54 AM - edited 03-15-2019 10:44 PM
Hi All,
Do you know on how to configure FAC at CME ?
I want to put PIN code when access to particular destination number
Thx,
Suryanto
05-13-2010 02:22 AM
Hi,
You can set pin only on Phone level not like CUCM. In CME FAC means Feature Access Code not Force Authorization code
05-13-2010 02:26 AM
Hi ,
Thx for the answer.
However what should be done is I want to have an International Call to be controlled by using PIN Code.
And i configure it at CME.
BR,
SURYANTO
05-13-2010 02:33 AM
Hi,
Please follow the below steps
under telephony service
login timeout 1
after-hours day Sun 00:01 23:59
after-hours day Mon 00:01 23:59
after-hours day Tue 00:01 23:59
after-hours day Wed 00:01 23:59
after-hours day Thu 00:01 23:59
after-hours day Fri 00:01 23:59
after-hours day Sat 00:01 23:59
after-hours block pattern 1 900 >> 9 is prefix
!
ephone 10
pin 12345
restart.
!
Now press Login softkey button dial 12345
will be able to dial international starting 900..................
Thanks,
05-13-2010 06:19 AM
This has been asked already PLENTY of times before, the options are using the after-hours or there is a script which is not supported but does the job.
You can find info on both methods by just searching FAC + CME using the search box at the top right on the page.
Please search NetPro for answers before posting a question.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
02-16-2011 09:55 AM
Now supported under CME 8.5. See:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmefac.html
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: