Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

configure fractional or partial T1 PRI with MGCP and Cisco CallManager

http://www.ciscotaccc.com/kaidara-advisor/voice/showcase?case=K14305072

I'm trying to find the step 2 settings to configure fractional or partial T1 PRI with MGCP in Cisco CallManager. It talks about copying and pasting this parameter, but where?

thanks,

Mike

2 REPLIES
Hall of Fame Super Silver

Re: configure fractional or partial T1 PRI with MGCP and Cisco C

You paste it into the "B-Channel Maintenance Status " field, you may need to click the "Advanced" setting in order to see it.

HTH,

Chris

New Member

Re: configure fractional or partial T1 PRI with MGCP and Cisco C

is there way to do this on the router and for it to keep its config even if the router reboots?

we are running into where the router will reboot and CCM will push its own config down.

420
Views
5
Helpful
2
Replies