Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configure FXS ports on a h323 gateway

Will someone point me to a configuration for FXS ports on a Cisco h323 gateway.  We are using CCM 4.2.

These analog lines should be able to call outside via 9xxx-xxxx, 91xxx-xxx-xxxx, make 5 digit dialing 1xxxx, 2xxxx.  Thanks

15 REPLIES

Re: Configure FXS ports on a h323 gateway

Hello friend,

This is FAQ. You can use the search tool.

You can follow this document: http://www.cisco.com/en/US/docs/ios/voice/fxs/configuration/guide/fxssccpsplmft.html

Hope it helps, please rate if it helps.

Kind regards,

- Adrian.

New Member

Re: Configure FXS ports on a h323 gateway

This is on a Cisco 1900 router.  These anlog lines will be used for faxing only.

New Member

Re: Configure FXS ports on a h323 gateway

attached is the show run.  The ports are 0/1/0 and 0/1/1   18701 and 18702

New Member

Re: Configure FXS ports on a h323 gateway

I can call the fxs port from a cisco phone but I cannot call out from FXS lines.

Re: Configure FXS ports on a h323 gateway

Hello,

Sorry, I didn't find the show run...

Kind regards.

New Member

Re: Configure FXS ports on a h323 gateway

hmmm.  I can see the attachement.  I'll try attaching it to this one too.  I'ts called analog.cap  Thanks

Re: Configure FXS ports on a h323 gateway

Hello,

I can see the file. Thanks. Let's see what dialpeers are matching when calling from your fax devices. For each call, please take debug voip ccapi inout.

Kind Regards.

New Member

Re: Configure FXS ports on a h323 gateway

debug attached.  Thanks

New Member

Re: Configure FXS ports on a h323 gateway

anyone?

Re: Configure FXS ports on a h323 gateway

What are the called and calling numbers???

New Member

Re: Configure FXS ports on a h323 gateway

calling number  - FXS x18701

called number = call manager phone x11399

Thanks

Re: Configure FXS ports on a h323 gateway

Please put no digit-strip the dial-peer 3 and remove the forward digits and test it again, if does not works collect debug voice ccapi and debug vpm signal at the same time while trying to make a call

New Member

Re: Configure FXS ports on a h323 gateway

Done - still didn't work.  Attached is the debug.  FYI  - becasue this gatway is also providing T1/PR! services you will see that traffic too.

New Member

Re: Configure FXS ports on a h323 gateway

Here is the other debug with the no strip command

New Member

Re: Configure FXS ports on a h323 gateway

I was ableto get 5 digit dialing to go over the WAN link but

still having trouble with 7 and 11 digit dialing.

See attached config and debug  Thanks

2333
Views
0
Helpful
15
Replies