i have a 2801 with a vic2-2bri and 4fxs voice ports.
Also the ccm is 5.0(x) and the gateway is configured as MGCP (I just hate MGCP for these simple implementation but i found it configured and i didn't want to change it!!Otherwise i would use H323 which i think behaves better)
A specific number that hits bri, gets translated and points to the faxmodem attached at the fxs. So i guess there is no conversion to voip?
This scenario works fine with voice (no extra congif needed with an analog phone attached to the FXS) but
in order to receive/send fax with no problems, is there something else i must add in:
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...