Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configure mgcp timers: Failover and keepalive intervals

Hi all,

i cannot find out where i must configure these timers!! the defaults are 30 and 15 seconds respectively but i need to lower them down.

Any ideas

1 REPLY

Re: Configure mgcp timers: Failover and keepalive intervals

Have you tried searching on the CallManager Service Parameters? Try under Clusterwide Parameters (Device - PRI and MGCP Gateway)

904
Views
0
Helpful
1
Replies
CreatePlease login to create content