Configure Phones missing from UC 500 Series Administration
I recently upgraded a UC-520 system from a very old version of CUE to the latest version 8.0.4. (UC 500 Series - Administration Version 8.0.2). I restored factory default because I had some issues and wanted to start fresh. Everything went seemingly well including TCP/IP setup, DHCP items, SIP Trunk configuration, etc. I can make and receive calls on the system just fine. I cannot seem to find where to configure the phones. I normally configure custom buttons, setup the users' name at the top, etc. I used to go to "configure" -> "phones" in the web admin console and now the option is not there. Did I forget to install something?
Re: Configure Phones missing from UC 500 Series Administration
I'm not opposed to using the CLI exclusively, I just wanted to make sure I didn't mess something up with the upgrade and this was an indicator of some component missing. Can I post any part of my config that would verify that the components are correctly installed?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.