Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Configure SNMP in CUCM for Monitoring

Hi all,

Does anyboby have information on configuring SNMP in CUCM for monitoring ? or the MIB information for CUCM 7.1 ?

Thanks in advance !!

D.

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Super Bronze

Re: Configure SNMP in CUCM for Monitoring

There is a chapter about this in the Servicibility Guide, including a checklist:

Understanding Simple Network  Management Protocol

Cisco Unified Serviceability  Administration Guide, Release 8.0(2)

4 REPLIES
VIP Super Bronze

Re: Configure SNMP in CUCM for Monitoring

There is a chapter about this in the Servicibility Guide, including a checklist:

Understanding Simple Network  Management Protocol

Cisco Unified Serviceability  Administration Guide, Release 8.0(2)

New Member

Re: Configure SNMP in CUCM for Monitoring

Hi Jonathan,

Thanks for responding to my post !! very much appreciate it.

Do you know if Cisco provide MIB information on CUCM services ? I am looking for the MIB OID number for each of CUCM service. My monitoring system requires the OID number to query the services.

Thanks again !!!

D.

Re: Configure SNMP in CUCM for Monitoring

Yes. A wealth of information on MIBs available with CUCM are provided in the CUCM Managed Services Guide:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/managed_services/ManagedServices.html

In particular, the following section should directly answer your question:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/managed_services/industry_mibs.html#wp1145376

You will want to review the sections on feature and network services.  I know the section headers reference CUCM 6x and they are in a CUCM 7x book, but the OIDs should still apply to 7x.

HTH.

Regards,
Bill

Please remember to rate helpful posts.

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

Page not Found !

Page not Found !

14297
Views
5
Helpful
4
Replies
CreatePlease to create content