Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

configure UCM with SIP account

Hi ,
Can someone guide me whom have experience with configure SIP account from SIP Provider with Cisco Voice Gateway, the idea is to point UCM users to point for all International calls to pass via Cisco Voice Gateway router then ------INTERNET -----SIP Provider :
Here is my SIP user account configuration:

sip-ua
authentication username 1777XXXXXXX password XXXXX
no remote-party-id
retry invite 4
retry response 3
retry bye 2
retry cancel 2
retry register 5
timers register 250
mwi-server ipv4:204.11.192.36 expires 3600 port 5060 transport udp unsolicited
registrar ipv4:204.11.192.36 expires 3600
sip-server ipv4:204.11.192.36

Regards,

SID

2 REPLIES
Green

Re: configure UCM with SIP account

In CUCM create a route pattern and point it to the Cisco VGW using

a SIP trunk

In GW just create your dial-peers to point to the SIP Provider

New Member

Re: configure UCM with SIP account

already I configure all what you have mentioned .....I forget to mentioned it..... should i contact SIP Provider maybe from their side …..i test the account with SIP software its working fine, what about if i used NATed IP address would find with me......or i need to got public IP Address for voice Gateway.

Your advices.

regards,

SID

358
Views
0
Helpful
2
Replies