Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configuring a Local Route Group

Hi All

I was configuring Local Route Group in CCM 7.x i am a little confused

1) I have created the Route list for each site now in Route List should i add both the Standard Local Route Group AND the Route Group for that site or only the Standard Local Route Group

2) In the Route Pattern On the RouteList/Gateway Field I dont see any Local Route Group Definition So how do i define which RL to use since Both sites uses the Same Route pattern. So what do i configure for this field

In the device pool for each device pool i have already mentioned the Local Route there

Please do Help

  • IP Telephony
2 REPLIES

Re: Configuring a Local Route Group

You no longer require a Route List per site. One Route List which selects the local route group can be used for all sites on the cluster and the calls will go out of the local gateway.

New Member

Re: Configuring a Local Route Group

thank you

one more query so in the route list i just have to mention standard local route group and create route patterns with that route list correct ?

how do we configue Tail end hop off using local route groups ?

540
Views
0
Helpful
2
Replies
This widget could not be displayed.