Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configuring a PRI E1

Hello,

I have to configure a router 3845 with one NM-HDV2-2T1/E1 and two PVDM2-64. I have typed the following commands:

(router-config)# card type e1 1 1

(router-config)# controller e1 1/0

(config-controller)# pri-group timeslots 1-31

And the router shows the following message in console:

% Not enough DSP resources available to configure pri-group on controller E1 1/0

% The remaining dsp resources are enough for 0 time slots.

% For current codec complexity, 2 extra dsp(s) are required to create this voice port.

Does anyone know what can I do? The only solution is to add more DSPs?

Thanks in advance and best regards.

Luis Elvira

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Silver

Re: Configuring a PRI E1

Since your PVDM modules are on the mainboard you need to issue the following:

voice-card 0

dspfarm

You will alos need to issue the following to be able to configure the PRI:

network-clock-participate slot 1

network-clock-select 1 E1 1/0

HTH, please rate all useful posts!

Chris

Hall of Fame Super Silver

Re: Configuring a PRI E1

No need to do this on voice-card 1 as that is the NM-HDV card and you have no PVDMs there.

Chris

6 REPLIES
Hall of Fame Super Silver

Re: Configuring a PRI E1

Can you post "sh diag" and "sh run"

Chris

New Member

Re: Configuring a PRI E1

I have atteached a txt file with show run and show diag outputs.

Best regards,

Luis Elvira

Hall of Fame Super Silver

Re: Configuring a PRI E1

Since your PVDM modules are on the mainboard you need to issue the following:

voice-card 0

dspfarm

You will alos need to issue the following to be able to configure the PRI:

network-clock-participate slot 1

network-clock-select 1 E1 1/0

HTH, please rate all useful posts!

Chris

New Member

Re: Configuring a PRI E1

Thanks for your help Crish.

One more question: could it be the voice-card 1? or it must be voice-card 0, where the command dspfarm will be typed.

Hall of Fame Super Silver

Re: Configuring a PRI E1

No need to do this on voice-card 1 as that is the NM-HDV card and you have no PVDMs there.

Chris

New Member

Re: Configuring a PRI E1

Thanks Chris

159
Views
4
Helpful
6
Replies