Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuring CME 9 for Transcoding

I am trying to find guidance on how to configure the DSP resources to work in an environment where I can't map the resource to an actual interface with a MAC-Address but only to the Loopback interface.  Thanks...                  

Everyone's tags (4)
3 REPLIES
Cisco Employee

Configuring CME 9 for Transcoding

If you mean the dspfarm profile name which by best practice uses the MAC address from the interface you will be using to reach CUCM/CME, that is just a best practice, you can name them whatever you like.

You neven bind the profile to the MAC, you bind to a signaling interface for SCCP.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Configuring CME 9 for Transcoding

I must use the Loopback interface as the CME interface and by using that I do not have a MAC Address to bind to in the MTP configuration.  that is my question is if using that interface what do i use for the Mac Address.

Bronze

Re: Configuring CME 9 for Transcoding

You can name the transcoder whatever you want. Even your name would work, you don't need a MAC!

Sent from Cisco Technical Support iPad App

439
Views
0
Helpful
3
Replies