EnergyWise questions. I have just updated the IOS (12.2SE1) on my 3560. The intent was to make the 3560 the EnergyWise (2.5) Domain controller (Parent). I created a domain name and shared-secret password .I have several phone types (7960,7962,7975 and 9951) listed as children in this domain. I can turn the phones on and off via the CLI recurrence commands with no issues. My desired result is to power down the phones from CUCM 8.5.1 by enablling Power Save Plus. Therein lies my problem. I enable power save plus, phone on, off, idle, audible alert EW domain, EW secret and allow EW overides. Can not seem to get phone (esp 9951) to power on and on as instructed. Do I need a EW Management station as a domain member to accomplish this? If not, then I'd welcome a nudge in right direction. Assistance appreciated.
Your solution worked as designed. The doc I referenced did not have the "energywise endpoint ...." command included. However, doc did reference the energywise management command. Did not specify that endpoint and domain had to to match. Those two simple command/explanations resolved my issue. Thanks again!!
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.