Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Configuring FXO card in CME 4.1

I am having trouble getting inbound dialing working on an FXO card. I only get a sigle ring on the inbound call and then a disconnect and dialtone. Is there a sample config of having an inbound number ring through to a phone that i can use as reference?

1 REPLY
Community Member

Re: Configuring FXO card in CME 4.1

For configuring FXO you need to set; at a minimum, the call progress tone specific for your country.

For example if you are in Great Briton:

voice-port 0/0/0

cptone gb

For sending all incoming calls on a voice port directly to an extension 222, you can use plar.

voice-port 0/0/0

connection plar 222

Hope this helps.

143
Views
0
Helpful
1
Replies
CreatePlease to create content