Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuring new E1 MFT

Hi all

Can you please confirm the correct configuration for a new E1 card install. Currently I have 1 30 channel E1 installed in the 3825 VG. I am assuming all I will have to do is add the controller and timeslots and I should be good to go. Then just add the translation patterns in the CUCM

Look forward to a reply

thanks

Simon

2 REPLIES

Re: Configuring new E1 MFT

It should be enough if you use MGCP as protocol. Still keep in mind you need DSP to use this E1 card.

Check your show diag DSP info with DSP calculator: http://www.cisco.com/cgi-bin/Support/DSP/cisco_prodsel.pl

rate if this help

New Member

Re: Configuring new E1 MFT

Thanks Konrad

The DSP tool is cool

127
Views
0
Helpful
2
Replies
CreatePlease login to create content