cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
248
Views
0
Helpful
2
Replies

Configuring new E1 MFT

simonmossman
Level 1
Level 1

Hi all

Can you please confirm the correct configuration for a new E1 card install. Currently I have 1 30 channel E1 installed in the 3825 VG. I am assuming all I will have to do is add the controller and timeslots and I should be good to go. Then just add the translation patterns in the CUCM

Look forward to a reply

thanks

Simon

2 Replies 2

It should be enough if you use MGCP as protocol. Still keep in mind you need DSP to use this E1 card.

Check your show diag DSP info with DSP calculator: http://www.cisco.com/cgi-bin/Support/DSP/cisco_prodsel.pl

rate if this help

Thanks Konrad

The DSP tool is cool

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: