I will try this . is this configuration will stop outgoing calls through E1 interface . i have to recive all incoming calls through E1 to my opertor phone. and outgoing calls should go through FXO port. If you ca please give me the configuration steps it will be very helpful
Like i have created hunt group to recive all Incoming calls from PRI E1 to operator phone . but im not sure about how it will know where to go . normally in FXO i ussed to mention connection plar opx XXX (extention ) number , here how it will work .
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.