Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configuring SF300-24p and 7942G

Hi I'm new to Cisco stuff and was just recently hired (lone system admin/IT staff in the company), Im a fresh graduate and this is my first hands on eperience on cisco devices, sadly the previous system admin left no network documentations, the network has 1 x 2801 router (I gained access by resetting the password) 1 x sf300-24p switch ( I cant access this because the console cable and IP address of the switch are missing) and 5x 7942g IP phones, the network is working fine as it is now I want to be prepared in case something happens to the config in the sf300, so how do you configure VOIP phones in the sf300? are they plug and play? or does it need special configurations? thanks and please bear with my inexperience. Godbless

  • IP Telephony
Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Blue

Configuring SF300-24p and 7942G

Hi

Yes, if you do not want QOS,POE etc related extra feature.

regards

Ronak Patel

Rate all helpful posts by clicking stars below the answer.

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
5 REPLIES
Blue

Configuring SF300-24p and 7942G

Hi

300 series switch support voice vlan concept so you will have to configure voice vlan and data vlan related configuraiton in this switch. Other configuration is pretty much not related to VOIP.

Regards

Ronak patel

Rate helpful posts by clicking stars below the answer.

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
New Member

Configuring SF300-24p and 7942G

so basically if I reset the switch to factory defaults, and lets say the IP phones are

int range fa0/1-5

switchport mode access

switchport access vlan  10 (my default and internet vlan)

switchport voice vlan 20 (my voice vlan)

so after that its all set?

Blue

Configuring SF300-24p and 7942G

Hi,

Yes if you donot want QOS, POE etc feature this is minimum what is required.

Regards

Ronak Patel

Rate all helpful posts by clicking stars below the answer.

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
Blue

Configuring SF300-24p and 7942G

Hi

Yes, if you do not want QOS,POE etc related extra feature.

regards

Ronak Patel

Rate all helpful posts by clicking stars below the answer.

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
New Member

Configuring SF300-24p and 7942G

thanks I was intimidated by the settings on 2801 that's why I was worrying on the switch side also because these were not discussed on my CCNA classes.

421
Views
0
Helpful
5
Replies
This widget could not be displayed.