Configuring speed dial and 7914 expansion module on Callmanager Express
I just finished deployment of IP telephony express of 26 users. The ccme version is cme-124-11XW1 and the IOS is c2800nm-advipservicesk9-mz.124-11.XW1.
The requirements include the configuration of speed dial on all the 7961 IP phones. Another requirement is adding of 7914 expansion module on the helpdesk phone (7961) and configuring speed dial on it.
I'm presently faced with the following challenges.
1) I configure the speed dial on the 7961 phones, but the speed dial display in only two of the buttons. On some of the phones the speed dial display only on one of the buttons
2) I added the 7914 and configured the needed speed dial, but this does not display on the buttons. All the buttons on the 7914 shows red continuously and nothing displays on the screen.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.