configuring standby MGCP gateway of a cisco 2811 and 2911 on CUCM 9.1
We have a CUCM 9.1 with a working MGCP gateway configured on a Cisco 2811 router with 4E1 lines. We have purchased another cisco 2911 with 4 E1 ports intended to act as a backup MGCP gateway for this call manager.
How can we configure the two so that if one fails the other one takes over the operations automatically?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...