configuring the bandwidth for a single isdn channel
Is there a way by which i can configuring the bandwidth for a single isdn channel.We have Isdn pri between mumbai n chennai.This link carries voice as well as data and is configured for DDR.Now the codec used is g729 24kbps with overhead.As an isdn channel is 64 kbp we can put two calls on a single channel.But this violates the rules as per the isp which could lead to a legal issue.So can we change the bandwidth to 24 kbps for each isdn channel which would suffice our need.Thanks in advance
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...