I`ve added a trunk group PSTN-OUTBOUND hunt-scheme sequential both up
Added it to the Serial Interface as below
interface Serial0/0/0:15 no ip address encapsulation hdlc isdn switch-type primary-qsig isdn incoming-voice voice trunk-group PSTN-OUTBOUND no cdp enable !
Tried to add the trunk grp to the Dial-peer but got the following error
GLBSSRSTVG01(config-dial-peer)#trunkgroup PSTN-OUTBOUND ERROR: voice port exists GLBSSRSTVG01(config-dial-peer)#
Then tried to add it to voice-port but got this
(config-voiceport)#trunk-group PSTN-OUTBOUND Error: Failed to add non-analog port to trunk group Configure in cas-custom mode or serial interface mode for T1/E1 digital ports and in BRI interface mode for BRI voice ports
My thinking is that I create a Trunk group called PSTN and then assign it to the Serials and then assign it to Dial-Peers- is this correct?
configuring trunk groups- reducing dial-peer - help needed
It sounds like you already have the port commands configured on your dial-peer (port 0/3/0:23 for example). You'll need to remove the port command in order to add the trunkgroup PSTN-OUTBOUND to your dial-peer which is why you're receiving the voice port exists error.
SIP traces provide key information in troubleshooting SIP Trunks, SIP
endpoints and other SIP related issues. Even though these traces are in
clear text, these texts can be gibberish unless you understand fully
what they mean. This document attempts to br...
Please find the attached HTML document, download and open it on your PC.
This provides an easy to use form where you simply answer a few
questions and it will render the proper jabber-config.xml file for you
to copy/paste. There is built in logic to verif...
CUCM Database Replication is an area in which Cisco customers and
partners have asked for more in-depth training in being able to properly
assess a replication problem and potentially resolve an issue without
involving TAC. This document discusses the bas...