We have a PRI terminated on a voice router with CUCM 8.5. Now clients are getting one more PRI to terminate on the router. they want calls to go on PRI A if "9" is pressed and PRI B if "0" is pressed initially. How can we go about this ??
If your PRI is added as MGCP, you can add the 2nd PRI as another Gateway on CUCM and create a copy of the old Route Patterns. change the 9 to 0 and point this RP to the new Gateway added on CUCM.
If you have the PRI setup as H323, you'd need to create Route Patterns with 0 dial and point it the same Gateway. On the Gateway, you need to create dial-peers which do a match based on 0 instead of 9 as it would be currently setup.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.