I have CME 4.1(0) running Cisco 2811 router with 4FXO cards and want to connect it to Siemens PBX. I have configured pots dial-peer for PBX with destination-pattern 1.. as PBX has extensions of 1xx. Here i am faciming couple of issues.
1. From IP Phone when i dial a valid extension, i.e. 129 it gives re-order tone. But when i tried 1129 (assuming that router is skipping first digit) the Analog phone at PBX got connected. But there are times that when i dial 1129 at IP Phone (ip communicator) it takes 112 extension discarding the last digit.
Can anyone tell how to resolve these issues.
2. Can i create a hunt group for 4FXO ports so that call can hunt on these ports.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...