Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Connecting Fax server with Cisco 2801 gateway

I wanna connect XMediusFAX fax server with Cisco 2801 gateway with vic2-2bri. When I send fax from outside fax server receive it (with problems, it's slow). But when I try to send fax from XMediusFAX router match dialpeer, bri goes up and then down. Fax server report that he couldn't establish lind with voip gateway. This is configuration:

voice service voip

fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback cisco

interface BRI0/3/0

no ip address

isdn switch-type basic-net3

isdn point-to-point-setup

isdn incoming-voice voice

dial-peer voice 100 pots

preference 5

destination-pattern 0T

direct-inward-dial

port 0/3/0

!

dial-peer voice 200 voip

preference 1

destination-pattern 348800

session target ipv4:10.1.1.224

dtmf-relay h245-signal

codec g711ulaw

fax rate 14400

fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback cisco

no vad

!

no dial-peer outbound status-check pots

What can be a problem?

2 REPLIES
Hall of Fame Super Gold

Re: Connecting Fax server with Cisco 2801 gateway

hello,

it is actually quite strange that the server can receive fax, because your BRI should be configure network side. Please see:

http://cisco.com/en/US/tech/tk652/tk653/technologies_configuration_example09186a008010ef6c.shtml

note: you can omit the command "line-power", however, it should not make a difference.

Hope this helps, please rate post if it does!

New Member

Re: Connecting Fax server with Cisco 2801 gateway

I will try explain the situation:

Faxserver (10.1.1.224) --> (FEth) Router --> ISDN BRI --> PSTN

244
Views
0
Helpful
2
Replies