Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Connecting FXS port to Bogen TAMB2 for paging

Hello,

I am trying to get an overhead paging system working. I have a FXS port connected to a TAMB2 and then to a 100Watt Avaya amp.

The current Avaya system has a paging port which connects to the amp.

I tested the FXS port first by connecting an analog phone and it is working.

when i make a test page, I do not hear anything on the overhead speakers.

I connected the FXS port to the Bogen, then the Bogen to the RJ11 port on the amp

Any thoughts,

Thanks in advance

Randall

1 REPLY

Connecting FXS port to Bogen TAMB2 for paging

Two ideas for you.

1. Are you sure you need TAMB? If Avaya amp has RJ-11 connector as opposed RCA or 3.5MM it kind of implies in might take an FXS or FXO port input.

2. Did you set dip switches on TAMB correctly?

http://www.bogen.com/products/pdfs/telephonepagepdfs/TAMB2m.pdf

TAMB also does not need -24V power supply if used on FXS port.

-- please remember to rate and mark answered helpful posts --
2967
Views
0
Helpful
1
Replies
CreatePlease login to create content