Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Connecting Pansonic tda600 with UC520

Hi ;

I want to connect a UC520 with Pansonic tda600 using  KX-TDA0490 VoIP card.Are these compatible . Any special configuration required on either side  ? Any sample config ?Thanks in advance 

Everyone's tags (1)
2 REPLIES
Cisco Employee

Hi Aijaz, from what I have

Hi Aijaz,

 

from what I have seen on the product sheet for the panasonic pbx, it does e1, bri.

(http://hbtcommunications.com/panasonic/kxtda_600.htm). If you have these capabilities on the module that you have bought for the panasonic pbx, then you can use E1 isdn/qsig as the connection between the panasonic side and cisco side.

 

On the cisco side, you will need to configure an e1 controller. this can be done in various ways.

http://icciev.expertscolumn.com/article/configure-cisco-2821-router-e1-trunk-gateway

http://www.cisco.com/c/en/us/tech/wan/t1-e1-t3-e3/tsd-technology-support-configure-guide.html

 

here's a discussion that might help.

https://supportforums.cisco.com/discussion/10462196/configuring-e1

 

Thanks

 

Hi,

Hi, If the Panasonic VoIP card support SIP you can integrante them with a SIP trunk, you should use so much tunning. Regards.
78
Views
0
Helpful
2
Replies