Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Connecting two CME

I have two CME one with ver 3.3 and other vith ver. 4.(0)1. I've made connection between them over serial link. Every telephones from side of CME 4.(0)1 can call any telephone on side of CME 3.3 but in opposite direction it's not possible. I've checked configuration but I cannot find mistake. Pls any advice or comment.

I tried to connect these two CME with H.323 and SIP but the results are the same.

3 REPLIES
Hall of Fame Super Gold

Re: Connecting two CME

Hi, can you configure SIP and take a trace on the 3.3? "term mon" and "debug ccsip message".

also please configure codec G711u under the dial peers.

New Member

Re: Connecting two CME

Well done! I've done it and it works! But I have a question why I cannot use the codec G729r8?

Hall of Fame Super Gold

Re: Connecting two CME

Yes you can use it. Configure the phones that you want to use g729 with this command under ephone.

Configure a voice class that contains, at least, g711u and g729b. Use this voice-class in place of "codec" under DP.

Remember that if the circuit between routers has high jitter or packet loss, g.729 will perform poorly. In that case, the best thing would be ILBC, but the matter get complicated because you would need universal transcoding that has been just release and can be hard to configure.

As an appreciation to those providing answers, please rate useful posts using the scrollbox below!

123
Views
15
Helpful
3
Replies