Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Connection E1 on VGW was full

I have Router VGW-1 and VGW-2 connected to E1 PSTN "X".

The problem is when connection E1 on VGW-1 was full the next connection from PSTN "X" will forward to VGW-2

then occur people that call from PSTN can't listen to any voice from VGW-2.

How can i show connection on router VGW and what is the couse of problem ?

2013-07-16 16_44_10-Drawing1 - Visio Professional.png

Thank you,

Akekarat Yingjaroen

2 REPLIES
Green

Connection E1 on VGW was full

Akekarat

The majority of one way transmission issues on IPT are caused by ip routing issues.

The speech path is between the ip phones and the ip address bound on the gateways.

Please ensure that you have bound an ip address for your protocol (H323 SIP MGCP) on the gateways and that

the Ip routing is set up in both directions betwee the phones default gateways and the voice gateway routers

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.

Connection E1 on VGW was full

thank you,

123
Views
0
Helpful
2
Replies
CreatePlease login to create content