I am having a problem changing out a connection PLAR. Currently it is set to 7210. I need to change it to be connection PLAR 3999. I change the PLAR to 3999 on each voice-port it was on and added dial-peers to correspond. I thouth that would be all that I had to do since the 7210 was a DN on Call Manager and the 3999 is a CTI route point on the same Call Manager. If I dial 3999 from one of the phones I reach the CTI route point with no problems. Once I change the connection PLAR to 3999 it rings once and then I get a standard busy tone. If I change the PLAR back to 7210 it works fine. The voice-port in questions is voice-port 1/1/0. I am including the configs. Can someone take a look and see what might be wrong? Thanks in advance
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...