After I set some translation profiles and rules for separate accounting purpose (shared call manager between 3 companies with separate voice ports) the full-consultative transfer stopped to work. When I want to transfer, both calls remain in hold state and I get a busy tone, although the local-consultative and blind transfer is still working.
However when I set the local-consult transfer and I want to initiate a three party hardware assisted ad-hoc conference only 2 party-s are joined the third party is dropped. If I set back to blind transfer the three party conference call is working fine.
I think you are missing the transfer pattern.In Cisco Unified CME 4.0(1) and later versions, the line button for a monitored line can be used as a DSS for a call transfer when the monitored line is in-use, provided that the actual call transfer can succeed; for example, when the monitored line is configured for Call Forward Busy or Call Forward No Answer.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...