To use consultative transfers with the UC500, you need to be running at least CME 4.3. You also need the global config "transfer-system full-consult".
Next you need the ephone-dn command "transfer-mode consult" on each dn that would like to take advantage of this feature. And thirdly you need an available line for seizing, so each ephone-dn needs to be at least a dual-line if not an octo-line configuration.
Well if you don't mind. We need to renew the cisco support. To do that we need the serial numbers off of the units. Specifically these are UC520 Phone System, CE520 Switch and CD520 Switch. These devices are mounted on the wall and not easy to access to obtain the serial numbers. We are able to get the UC520. Is there a a way to see the serial numbers from within the Cisco Configuration manager?
Using either Telnet or SSH, whichever you have setup, connect to the devices in question. You will need to connect to the ce520s individually. Use the "show version" command. Towards the bottom you should see a Processor Board ID followed by a string. That string is the Serial Number of the device.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4