Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CONTRAST on 7971/7975

does anyone know why i am unable to change the contrast on my 7971/7975 phones

all other settings work OK but contrast setting is dimmed and not accessible

8 REPLIES
New Member

Re: CONTRAST on 7971/7975

go to the CCM admin page > find/select your 7971 > at the "phone configuration page", go to the "Product Specific Configuration" section > look for parameter "Settings Access" and verify that you have it set to "Enabled".

Also is it working on "low-power mode"?

New Member

Re: CONTRAST on 7971/7975

settings access is enabled and i can access all other settings OK such as brightness and colour. it's just contrast that is "greyed"

not sure what you mean bye low power mode ?

i have the display switched off other than when an incomming call switches it on and the display timeout is set for 120 seconds.

New Member

Re: CONTRAST on 7971/7975

Hi,

have you solved this issue?

We're having the same behavior on 7971/7970 with CUCM 7.0.2.

setting access is enabled

New Member

Re: CONTRAST on 7971/7975

still got the problem, what firmware are you using ?

New Member

Re: CONTRAST on 7971/7975

SCCP 8.4-3 and 8.4-4

New Member

Re: CONTRAST on 7971/7975

i'm using SIP 8.4.4

New Member

Re: CONTRAST on 7971/7975

one other point i have some on power cubes and some on POE and they all do it.

so i dont think it's a PSU issue

New Member

Re: CONTRAST on 7971/7975

I agree, I don't think it's a Power Issue

I've tried PoE with Cat4500 and

2821

Also using the Power Cube didn't change anything.

I've tested this Issue with Firmware 8.5.2 and 8.3.4, however still no solution...

393
Views
0
Helpful
8
Replies
CreatePlease to create content