I have 3 PRI providers to my Voice gateway router, provider 1, provider 2, provider 3. Each may give cost effective in terms of local, STD, ISD. Incase if provider 1 is giving cost effective for ISD than provider 2 & 3, i want all the calls to go via the provider 1. If STD is cost effective with provider 2, so my call has to be routed thro it.
You just to create separate Route Patterns in CCM 9.1!, 9.001! etc if you use MGCP or on the actual Gateway if you use H323 dial-peers- Destination-pattern 91T 9011T, 900T etc. Depending the cost you point your route to the circuit/ Provider
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...