I have a site that is far away in a small town that the carrier can not offer a PRI or T1 CAS. So, I have to stick with the 8 DID trunk and 8 COT trunks that currently go into a Nortel option 11 PBX. I want to convert the site to VoIP so I need to figure out what type of card either FXS or FXO the COT trunks will need. I know the DID trunks will need a FXS card and I think the COT trunks will use a FXO card is that correct?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...