Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

create profile sync - what this command is used for?

Dear all,

under

voice register global

there should be also

create profile sync ...

what this command is used for?

Regards

2 ACCEPTED SOLUTIONS

Accepted Solutions
Cisco Employee

create profile sync - what this command is used for?

To know more about command " Create Profile " please refer http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/command/reference/cme_c1ht.html#wp1181212

Hope it helps ?


GP.

Pls rate helpful posts by clicking on stars below the post !!

Cisco Employee

Re: create profile sync - what this command is used for?

The actual command is " Create Profile ". Once you issue this command, CME takes time before coming back to command prompt because it generates the configuration files used for provisioning SIP phones and writes the files to the location specified with the tftp-path command.

After issuing this command, see " Show Run " & you will see Sync & the hexadecimal digits ahead of Create Profile command.

Hope it helps ?


GP.

Pls rate helpful posts !!

6 REPLIES
Cisco Employee

create profile sync - what this command is used for?

To know more about command " Create Profile " please refer http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/command/reference/cme_c1ht.html#wp1181212

Hope it helps ?


GP.

Pls rate helpful posts by clicking on stars below the post !!

New Member

create profile sync - what this command is used for?

Thank You,

but why in sample configuration there is always a numer?

for example:

create profile sync 000410054377842A

Cisco Employee

Re: create profile sync - what this command is used for?

The actual command is " Create Profile ". Once you issue this command, CME takes time before coming back to command prompt because it generates the configuration files used for provisioning SIP phones and writes the files to the location specified with the tftp-path command.

After issuing this command, see " Show Run " & you will see Sync & the hexadecimal digits ahead of Create Profile command.

Hope it helps ?


GP.

Pls rate helpful posts !!

New Member

create profile sync - what this command is used for?

and what about

destination-pattern

what is this used for?

Cisco Employee

Re: create profile sync - what this command is used for?

" destination-pattern " is used in dial-peer config. It is used for indicating the dialed number/pattern. If the call matches that destination pattern then configured action in dial-peer will be applied to it. e.g. if the call matches " Destination pattern " of 9T, then usually it is an outgoing dial-peer to PSTN & thus the call will be routed through PRI port which connects the enterprise to PSTN. Similar logic applies to incoming or intersite dial-peer too.

GP.

Pls rate helpful posts !!

Cisco Employee

create profile sync - what this command is used for?

Just to add, here is the document explaining more about " Destination Pattern "

http://www.cisco.com/en/US/docs/ios/12_2/voice/configuration/guide/vvfpeers.html#wp1258752

Hope it helps

GP.

Pls rate helpful posts !!

2150
Views
5
Helpful
6
Replies
CreatePlease login to create content